Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 124)

110 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
User Exec Commands
3
cluster-cli
User Exec Commands
Use this command to cluster all the CLI pertaining to the context it appears. This feature is useful
to configure each switch in the cluster by logging in to one switch. This eliminates administrator
time and effort N-1 times (if there are N switches in the cluster).
A new context called redundancy is created to support cluster-cli. Any commands executed under
this context are executed to all members of the cluster.
Syntax
cluster-cli enable
Parameters
Example
RFS7000(config)#show redundancy-members
Member ID : 192.168.100.1
Member State : Peer Seen
Member First Seen : Mar 15 16:24:54 2008
Member Last Seen : Mar 15 16:25:00 2008
Number of HB sent : 38044
Number of HB received : 3
Number of Update sent : 0
Number of Update received : 0
Member Standby Mode : Primary
Member AP adoption count : 0
Member Installed License Count: 0
Member Radio portal Count : 0
Member Associated MU Count : 0
Member Rogue AP detected Count: 0
Member Self Healing AP Count : 0
Member Switch Adopt Capacity : 0
Member Running Image Version :
RFS7000(config)#
RFS7000:cluster-cli#show version
*** START: Response from member: 172.20.15.18 ****
RFS7000 version 4.1.0.0-040GR
Copyright © 2010 Motorola, Inc.
Booted from primary.
Switch uptime is 7 days, 4 hours 28 minutes
*** END: Response from member: 172.20.15.18 ****
RFS7000 version 4.1.0.0-040GR
Copyright © 2010 Motorola, Inc.
Booted from primary.
Switch uptime is 7 days, 4 hours 28 minutes
RFS7000:cluster-cli#
enable Enables cluster context.