Gated sweep – Agilent Technologies N9010A User Manual
Page 28
28
Chapter 1
Agilent EXA Signal Analyzer
Frequency and Time
External Triggers
TV Triggers
Triggers on the leading edge of the selected
sync pulse of standardized TV signals.
Amplitude Requirements
–65 dBm minimum video carrier power at
the input mixer, nominal
Compatible Standards
NTSC-M,
NTSC-Japan,
NTSC-4.43,
PAL-M, PAL-N,
PAL-N Combination,
PAL-B/-D/-G/-H/-I.
PAL-60, SECAM-L
Field Selection
Entire Frame, Field
One, Field Two
Line Selection
1 to 525, or 1 to 625,
standard dependent
a. The highest allowed mixer level depends on the IF Gain. It is nominally –10 dBm for Preamp Off and
IF Gain = Low.
b. Noise will limit trigger level range at high frequencies, such as above 15 GHz.
Description
Specifications
Supplemental Information
Gated Sweep
Gate Methods
Gated LO
Gated Video
Gated FFT
Span Range
Any span
Gate Delay Range
0 to 100.0 s
Gate Delay Settability
4 digits,
≥100 ns
Gate Delay Jitter
33.3 ns p-p (nominal)
Gate Length Range
(Except Method = FFT)
100 ns to 5.0 s
Gate length for the FFT method is fixed at
1.83/RBW, with nominally 2% tolerance.
Gated Frequency and
Amplitude Errors
Nominally no additional error for gated
measurements when the Gate Delay is
greater than the MIN FAST setting
Gate Sources
External 1
External 2
Line
RF Burst
Periodic
Pos or neg edge triggered
Description
Specifications
Supplemental Information