Agilent Technologies N9010A - Manual (Page 113)

Chapter 7 113
Option CRP - Connector Rear, Arbitrary IF Output
Other Connector Rear, Arbitrary IF Output Specifications
Other Connector Rear, Arbitrary IF Output
Specifications
Aux IF Out Port
Arbitrary IF Out
Description Specifications Supplemental Information
Connector SMA female Shared with other options
Impedance 50
Ω (nominal)
Description Specifications Supplemental Information
Arbitrary IF Out
IF Output Center Frequency
Range 10 to 75 MHz
Resolution 0.5 MHz
Conversion Gain at the RF Center
Frequency –1 to +4 dB (nominal) plus RF frequency
response
a
a. “Conversion Gain” is defined from RF input to IF Output with 0 dB mechanical attenuation and the
electronic attenuator off. The nominal performance applies with zero span.
Bandwidth
Highpass corner frequency 5 MHz (nominal) at –3 dB
Lowpass corner frequency 120 MHz (nominal) at –3 dB
Output at 70 MHz center
Low band; also, high band with
preselector bypassed
100 MHz (nominal)
b
b. The bandwidth shown is in non-preselected bands. The combination with preselection (see footnote c )
will reduce the bandwidth.
Preselected bands Depends on RF center frequency
c
c. See “Preselector Bandwidth” on page 31 .
Lower output frequencies Subject to folding
d
d. As the output center frequency declines, the lower edge of the passband will fold around zero hertz.
This phenomenon is most severe for output frequencies around and below 20 MHz. For more informa-
tion on frequency folding, refer to X-Series Spectrum Analyzer User’s and Programmer’s Reference.
Phase Noise Added noise above analyzer noise
e
e. The added phase noise in the conversion process of generating this IF is nominally –88, –106, and
–130 dBc/Hz at offsets of 10, 100, and 1000 kHz respectively.
Residual Output Signals –88 dBm or lower (nominal)
f
f. Measured from 1 MHz to 150 MHz.