Agilent Technologies N9010A - Manual (Page 200)

200 Chapter 21
Bluetooth Measurement Application
Enhanced Data Rate (EDR) Measurements
Enhanced Data Rate (EDR) Measurements
Description Specifications Supplemental Information
EDR Relative Transmit Power This measurement is a Transmit
Analysis measurement and
supports average and peak power
in conformance with Bluetooth
RF test specification
2.1.E.0.5.1.12.
Packet Type 2-DH1, 2-DH3, 2-DH5, 3-DH1,
3-DH3, 3-DH5
Payload PRBS9, BS00, BSFF, BS55
Synchronization DPSK synchronization sequence
Trigger External, RF Burst, Periodic
Timer, Free Run, Video
Supported measurements Power in GFSK header, power in
PSK payload, relative power
between GFSK header and PSK
payload
Range
a
a. When the input signal level is lower than –40 dBm, the analyzer’s preamp should be turned on and the
attenuator set to 0 dB.
+30 dBm to –70 dBm
Absolute Power Accuracy
b
(20 to 30°C, Atten = 10 dB)
b. Absolute power accuracy includes all error sources for in-band signals except mismatch errors and
repeatability due to incomplete averaging. It applies when the mixer level is high enough that measure-
ment floor contribution is negligible.
±0.29 dB (95th percentile)
Measurement floor –70 dBm (nominal)