Agilent Technologies N9010A - Manual (Page 194)

194 Chapter 21
Bluetooth Measurement Application
Basic Rate Measurements
Description Specifications Supplemental Information
Initial Carrier Frequency
Tolerance This measurement is a Transmit
Analysis measurement and
supports average and peak power
in conformance with Bluetooth
RF test specification
2.1.E.0.5.1.10.
Packet Type DH1, DH3, DH5, HV3
Payload PRBS9, BS00, BSFF, BS0F,
BS55
Synchronization Preamble
Trigger External, RF Burst, Periodic
Timer, Free Run, Video
RF input level range
a
+30 dBm to –70 dBm
Measurement range Nominal channel freq ± 100 kHz
(nominal)
Measurement Accuracy
b
±100 Hz + tfa
c
(nominal)
a. When the input signal level is lower than –40 dBm, the analyzer’s preamp should be turned on and the
attenuator set to 0 dB.
b. Example, using 1 ppm as frequency reference accuracy of the analyzer, at frequency of 2.402 GHz,
frequency accuracy would be in the range of ±(2.402 GHz
× 1 ppm) Hz ± 100 Hz = ±2402 Hz ± 100 Hz
= ±2502 Hz.
c. tfa = transmitter frequency × frequency reference accuracy.