Agilent Technologies N9010A - Manual (Page 109)

Chapter 6 109
Option CR3 - Connector Rear, 2nd IF Output
Other Connector Rear, 2nd IF Output Specifications
Other Connector Rear, 2nd IF Output Specifications
Aux IF Out Port
Second IF Out
Description Specifications Supplemental Information
Connector SMA female Shared with other options
Impedance 50
Ω (nominal)
Description Specifications Supplemental Information
Second IF Out
Output Center Frequency
SA Mode 322.5 MHz
I/Q Analyzer Mode
IF Path
≤ 25 ΜΗz
322.5 MHz
IF Path
40 ΜΗz
250 MHz
Conversion Gain at 2nd IF
output center frequency –1 to +4 dB (nominal) plus RF frequency response
a
a. “Conversion Gain” is defined from RF input to IF Output with 0 dB mechanical attenuation and the
electronic attenuator off. The nominal performance applies in zero span.
Bandwidth
Low band Up to 140 MHz (nominal)
b
b. The passband width at –3 dB nominally extends from IF frequencies of 230 to 370 MHz. When using
IF paths with center frrequencies of 250 MHz or 322.5 MHz, the passband will therefore be asymmet-
ric.
High band
With preselector Depends on RF center frequency
c
c. The YIG-tuned preselector bandwidth nominally varies from 55 MHz for a center frequencies of
3.6 GHz through 57 MHz at 15 GHz to 75 MHz at 26.5 GHz. (Refer to page 23 for details.) The prese-
lector effect will dominate the passband width.
Preselector bypassed
(Option MPB) Up to 410 MHz nominal
d
d. The passband width at –6 dB nominally extends from 100 to 510 MHz. Thus, the maximum width is
not centered around the IF output center frequency.
Residual Output Signals –94 dBm or lower (nominal)