Agilent Technologies N9010A - Manual (Page 192)

192 Chapter 21
Bluetooth Measurement Application
Basic Rate Measurements
Basic Rate Measurements
Description Specifications Supplemental Information
Output Power This measurement is a Transmit
Analysis measurement and
supports average and peak power
in conformance with Bluetooth
RF test specification
2.1.E.0.5.1.3.
Packet Type DH1, DH3, DH5, HV3
Payload PRBS9, BS00 ,BSFF, BS0F,
BS55
Synchronization RF Burst or Preamble
Trigger External, RF Burst, Periodic
Timer, Free Run, Video
Supported measurements Average power, peak power
Range
a
a. When the input signal level is lower than –40 dBm, the analyzer’s preamp should be turned on and the
attenuator set to 0 dB.
+30 dBm to –70 dBm
Absolute Power Accuracy
b
(20 to 30°C, Atten = 10 dB)
b. Absolute power accuracy includes all error sources for in-band signals except mismatch errors and
repeatability due to incomplete averaging. It applies when the mixer level is high enough that measure-
ment floor contribution is negligible.
±0.29 dB (95th percentile)
Measurement floor –70 dBm (nominal)