Agilent Technologies N9010A - Manual (Page 193)

Chapter 21 193
Bluetooth Measurement Application
Basic Rate Measurements
Description Specifications Supplemental Information
Modulation Characteristics This measurement is a Transmit
Analysis measurement and
supports average and peak power
in conformance with Bluetooth
RF test specification
2.1.E.0.5.1.9.
Packet Type DH1, DH3, DH5, HV3
Payload BS0F, BS55
Synchronization Preamble
Trigger External, RF Burst, Periodic
Timer, Free Run, Video
Supported measurements Min/max
Δf1avg
min
Δf2max (kHz)
total
Δf2max > Δf2max lower
limit (%)
min of min
Δf2avg / max Δf1avg
pseudo frequency deviation (
Δf1
and
Δf2)
RF input level range
a
+30 dBm to –70 dBm
Deviation range ±250 kHz (nominal)
Deviation resolution 100 Hz (nominal)
Measurement Accuracy
b
±100 Hz + tfa
c
(nominal)
a. When the input signal level is lower than –40 dBm, the analyzer’s preamp should be turned on and the
attenuator set to 0 dB.
b. Example, using 1 ppm as frequency reference accuracy of the analyzer, at frequency of 2.402 GHz,
frequency accuracy would be in the range of ±(2.402 GHz
× 1 ppm) Hz ± 100 Hz = ±2402 Hz ± 100 Hz
= ±2502 Hz.
c. tfa = transmitter frequency × frequency reference accuracy.