Teledyne LeCroy Sierra M122 User Manual - Manual (Page 97)

Sierra M122 SAS/SATA Protocol Analyzer User Manual 95
SAS/SATA Software Menus and Toolbars Teledyne LeCroy
specify the number of times that the pattern must occur before triggering or proceeding
in the trigger sequence.
Figure 2.65: Number of Occurrences DIalog
Note: The system counts events on each link independently, causing a trigger whenever the number of
occurrences on any link equals the specified value.
Triggering Order
As you define and add triggering patterns, they display under the Trigger category in the
Project Tree sequentially, in the order in which you entered them. When the project runs,
the Analyzer detects the occurrence of each pattern in order and triggers on the last one.
You can reorder the sequence of triggering patterns. To change the sequence order,
highlight a trigger pattern and use the Up or Down arrow to move it to a new position.
Figure 2.66: Triggering Order