Teledyne LeCroy Sierra M122 User Manual - Manual (Page 211)

Sierra M122 SAS/SATA Protocol Analyzer User Manual 209
Preferences Teledyne LeCroy
Anchor the Selection Bar
You can anchor the selection bar of the Spreadsheet View.
Set the Anchor row as sync. point: Other views synchronize based on the contents of the
anchor row.Other
Repeat decoded command in frame column: The spreadsheet shows the name of the
command in front of all frames in the Command column. Otherwise, it will show the
name of the command only in front of the SSP command frame.
Decode CDB of Commands: The spreadsheet shows name of command in command
column, otherwise shows CDB of command in command column.
Show ‘Sector Count’ instead of ‘Xfer Length’ (SATA only): Display sector count.
3.16.4 Column View Tab
Figure 3.139: Preferences Dialog Column View Tab
Note: Column View is not supported for traces captured with the Sierra M122.
Other
Display pre‐filtered cells as blank in column view: The software shows pre‐filtered data
(already filtered in the capture project), as blank cells. Otherwise, it will show them as
“pre‐filtered” cells.