Teledyne LeCroy Sierra M122 User Manual - Manual (Page 326)

Teledyne LeCroy Sierra Trainer Generation Language
324 Sierra M122 SAS/SATA Protocol Analyzer User Manual
SPEED_NEG_ALIGN1 Generator will go through SPEED_NEG_ALIGN1
stage of SAS SpeedNeg process using current
SPEED_NEG_ALIGN1 settings.
Set Speed = LINK_SPEED_1_5G Generator will change speed to 1.5G (if
MultiSpeed is enabled)
. 
This setting is not applied when
Advanced Connect is set.
Set Speed = LINK_SPEED_3G Generator will change speed to 3G (if
MultiSpeed is enabled).
This settings is not applied when
Advanced Connect is set.
Set Speed = LINK_SPEED_6G Generator will change speed to 6G (if
MultiSpeed is enabled).
This setting is not applied when
Advanced Connect is set.
Set Speed = LINK_SPEED_12G Generator will change speed to 12G (if
MultiSpeed is enabled).
This setting is not applied when
Advanced Connect is set.
DevSlp Makes the device sleep signal high. Trainer
doesn’t go to Electric idle mode automatically
after Devslp command. We can force trainer to
go to DC Idle mode using the “disconnect “
command after Devslp command. This
command works when Generation mode is
GEN_MODE_SAS_INITIATOR or
GEN_MODE_SATA_HOST
Exit_DevSlp Makes Device sleep signal low (comes out of
device sleep mode). This command works when
Generation mode is GEN_MODE_SAS_INITIATOR
or GEN_MODE_SATA_HOST
SEND_TRAIN_RX_WINDOW (This Command is used in Train Windows). This
command works exactly same as
"Send_Train_TrainDone."
SEND_TRAIN_TX_WINDOW (This Command is used in Train Windows).
Send_Phy_Capability Generator will send PHY Capability Bits.
(this command is used in SNW3).
Send_Train_TrainDone Generator will send Train/Train Done Patterns.
(This Command is used in Train Windows).
Delay (#) Generator will wait until # ns before executing
next command.