Teledyne LeCroy Sierra M122 User Manual - Manual (Page 242)

Teledyne LeCroy Scenario Actions
240 Sierra M122 SAS/SATA Protocol Analyzer User Manual
 The pattern must be defined at a specific offset in the frame.
 The pattern and mask must be specified in the same format as specified in the
SATA Standard.
For example, for Register H ‐> D FIS:
Pattern: 0x00000027
Mask: 0x000000FF
Offset: 0
SOF Type: SATA_SOF
4.8 Scenario Actions
After you enter the set of events for a test state, the menu‐driven interface prompts you
for the corresponding action or set of actions. If you define multiple actions, the actions
occur simultaneously.
Figure 4.16: Action Properties Dialog
The following table lists supported actions. Note that some of these actions only apply to
creating sequences.