Teledyne LeCroy Sierra M122 User Manual User Manual
Page 345
Sierra M122 SAS/SATA Protocol Analyzer User Manual
343
Sierra Trainer Generation Language
Teledyne LeCroy
Phy Capabilities Settings
OOB_SpeedNeg_Phy_start
The START bit shall be set to one. The phy’s receiver
shall use this bit to establish the timing for the
subsequent bits.
OOB_SpeedNeg_
Phy_txSSCtype
A TX SSC TYPE bit set to one indicates that the phy’s
transmitter uses center‐spreading SSC when SSC is
enabled.
A TX SSC TYPE bit set to zero indicates that the phy’s
transmitter uses down‐spreading SSC when SSC is
enabled or that the phy does not support SSC.
OOB_SpeedNeg_Phy_RLLR
The REQUESTED LOGICAL LINK RATE field indicates if
the phy supports multiplexing and, if so, the logical
link rate that the phy is requesting.
OOB_SpeedNeg_
Phy_g1WithoutSSC
A G1 WITHOUT SSC bit set to one indicates that the
phy supports G1 (i.e., 1.5 Gbps) without SSC.
A G1 WITHOUT SSC bit set to zero indicates that the
phy does not support G1 without SSC.
OOB_SpeedNeg_
Phy_g1WithSSC
A G1 WITH SSC bit set to one indicates that the phy
supports G1 (i.e., 1.5 Gbps) with SSC.
A G1 WITH SSC bit set to zero indicates that the phy
does not support G1 with SSC.
OOB_SpeedNeg_
Phy_g2WithoutSSC
A G2 WITHOUT SSC bit set to one indicates that the
phy supports G2 (i.e., 3 Gbps) without SSC.
A G2 WITHOUT SSC bit set to zero indicates that the
phy does not support G2 without SSC.
OOB_SpeedNeg_
Phy_g2WithSSC
A G2 WITH SSC bit set to one indicates that the phy
supports G2 (i.e., 3 Gbps) with SSC.
A G2 WITH SSC bit set to zero indicates that the phy
does not support G2 with SSC.
OOB_SpeedNeg_
Phy_g3WithoutSSC
A G3 WITHOUT SSC bit set to one indicates that the
phy supports G3 (i.e., 6 Gbps) without SSC.
A G3 WITHOUT SSC bit set to zero indicates that the
phy does not support G3 without SSC.
OOB_SpeedNeg_
Phy_g3WithSSC
A G3 WITH SSC bit set to one indicates that the phy
supports G3 (i.e., 6 Gbps) with SSC.
A G3 WITH SSC bit set to zero indicates that the phy
does not support G3 with SSC.
OOB_SpeedNeg_
Phy_g4WithoutSSC
A G4 WITHOUT SSC bit set to one indicates that the
phy supports G4 (12 Gbps) without SSC.
A G4 WITHOUT SSC bit set to zero indicates that the
phy does not support G4 without SSC.
Setting
Default
Value
Description