Teledyne LeCroy Sierra M122 User Manual - Manual (Page 168)

Teledyne LeCroy Navigation + View Toolbar
166 Sierra M122 SAS/SATA Protocol Analyzer User Manual
Filter Descend Packets if Ascent Packet is Filtered
If you check the Filter descend packets if ascend packet is filtered checkbox, the
application will only filter onward from the highlighted trace selection bar.
If you uncheck this option, the software only filters the filtered packet. For example, if
this option is checked and any SCSI command is selected, all transport and link packets of
this command are filtered. If you unchecked this option, only selected SCSI commands
are filtered.
3.6.4 Selectable Filter Options for SAS
The SAS Filter Options are:
 Command Data Pattern
 Bus Condition
 Primitive
 Incomplete Frames
 Address Frames
 SSP Frames
 SMP Frames
 STP Frames
 SCSI Commands
 SMP Commands
 Task Management Functions
 ATA Commands
 SCSI Command Status (see “Filter Check Condition” on page 167 )
 Source SAS Address
 Destination SAS Address
 Pair SAS Address
 Protocol Error
 STP Port
 Tag (see “Filter by Tag Number” on page 168 )
 ATAPI SCSI Command
 Device Sleep
 Miscellaneous (see “Filter Miscellaneous” on page 168 )
 Training Sequence
Command Data Pattern
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
captured Command Data Patterns in the Trace Viewer.
Bus Condition
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
captured Bus Conditions in the Trace Viewer.
Incomplete Frames
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
Incomplete Frames in the Trace Viewer.