Teledyne LeCroy Sierra M122 User Manual - Manual (Page 45)

Sierra M122 SAS/SATA Protocol Analyzer User Manual 43
Chapter 2
Protocol Analysis
A default analyzer project is created automatically when the application starts. An
analyzer project contains all the settings for capturing, triggering and memory usage. A
project can be saved as a *.sac files for later use.
2.1 Easy Mode (Pre-Defined Setups)
After you install the Protocol Suite software (see “Software Installation” on page 18 ) and
set up the Analyzer (see “Hardware Setup” on page 19 ), launch the Protocol Suite
software (see “Launching Your Analyzer” on page 31 ) to display the default Protocol
Analyzer in Easy Mode at the Capture tab.
The default Protocol Analyzer uses the Easy Mode which allows triggering and data
capture.
2.1.1 Main Window
Use the Easy Mode to get a comprehensive overview of your analyzer’s capabilities. Use
the default Analyzer Project or create a new project.
For SAS: on the Analyzer Menu Bar, click File > New > SAS Protocol Analyzer to open a SAS
Protocol Analyzer dialog.