Teledyne LeCroy Sierra M122 User Manual - Manual (Page 52)

Teledyne LeCroy SAS/SATA Software Menus and Toolbars
50 Sierra M122 SAS/SATA Protocol Analyzer User Manual
Launching the CrossSync Control Panel
To launch CrossSync from the SAS/SATA Protocol Suite software application, click on File
and select Launch CrossSync Control Panel (see
Figure 2.6 on page 50 ). Or, you can
launch CrossSync from the ‘Start’ menu.
Figure 2.6: Launching CrossSync from the SAS/SATA Protocol Suite Application
Please refer to the CrossSync Control Panel User Manual for more information.
2.2.7 Save Workspace
Viewing parameters can be saved in a workspace as a .wss file.
After you open a trace and select views, you can save the viewing parameters in a
workspace file. Select File > Save Workspace to open a Save As dialog. Save the current
workspace as a .wss file.
To set default workspace viewing parameters, select Setup > Preferences . In the Default
Workspace field, enter the path and name of a saved workspace .wss file.
The workspace can be switched after opening a trace file. Select File > Open to open
another workspace and select a .wss file.
2.2.8 Saving a Trace Capture
You can save a Trace Capture by selecting Save from the File menu, or select Save As to
save as the trace capture for review at a later time using the following dialog.