Teledyne LeCroy Sierra M122 User Manual - Manual (Page 283)

Sierra M122 SAS/SATA Protocol Analyzer User Manual 281
Sierra Trainer Menus Teledyne LeCroy
5.1.2 Setup Menu
 Update Sierra Device: See “Update Device” on page 213 .
 Port Configuration:
You can select different combinations of Trainer with Analyzer and Jammer. When
running two different applications on the ports, you must set the same port
configuration in both of them. See
“Ports Configuration” on page 101 . The following
describes possible configurations:
 Analyzer and Trainer on same port: You can generate initiator/target traffic
and also capture the traffic generated.
 Analyzer and Trainer on same port, and Analyzer and Trainer on another
port: You can generate initiator/target traffic and also capture the traffic gen‐
erated on two ports.
 Trainer on one port, Analyzer on another port, and Analyzer on a third port:
Trainer is run on a port generating initiator/target traffic and two port Ana‐
lyzers run on two other ports capturing the traffic of those ports.
 Trainer on two ports, and Analyzer on two ports: Two Trainers run on two
ports generating initiator/target traffic and two Analyzers run on two other
ports capturing the traffic of those ports.
 Trainer and Jammer on same port: You can generate initiator/target traffic
and also inject errors on the traffic between initiator and target on the port.
Note: See “Multi‐Port Trainer Script Assignments to Links” on page 298 .
Display Options: Selects what information to display. See “Display Options” on page 359 .
Figure 5.3: Trainer Setup Menu
5.1.3 Generate Menu
Start Generation: Causes the Generator to begin generation.
Stop Generation: Causes the Generator to stop generation.
Resume Generation: Causes the Generator to resume generation after a stop.
Connect Link: Automatically bring the linkup to the Host, Device, Initiator, or Target
connected to the Generator.
Disconnect Link: Disconnect link.
Connect Parameters: Set the “Identify” frame parameter settings to keep the link
connected. See
“Connection Parameters” on page 365 .
Generation Options: Setup the Generation Rules. See “Generation Options” on page 348 .