EVS IPDirector Version 4.3 - October 2007 Part 3 User's Manual - Manual (Page 95)

Issue 4.3.C IP Director Version 4.3 – User Manual – Part 3: Ingest and Play-Out
EVS Broadcast Equipment
82
The play-list is loaded into the Clip-List tab, either as part of
another play-list or as an independent play-list.
Note
The play-list can also be loaded, via the Remote Panel
or the Play-List Editor, onto the channel open in the
Control Panel. In this case, the play-list will
automatically be loaded in the Control Panel without
any message being displayed.
4.17 MOVING WITHIN MEDIA
4.17.1 H
OW TO
J
UMP TO A
G
IVEN
T
IMECODE OF THE
L
OADED
M
EDIA
To jump to a given timecode of a loaded media, proceed as
follows:
1. Enter the time code value from where you want to play the
loaded media in the left timecode field. This can also be
before the IN point or after the OUT point.
2. Press ENTER.
The position indicator jumps to the specific timecode on the
loaded media and the media is played.
If the media is a clip, the clip is played from the specified
timecode when you select the Play button.
If the media is a train, the train is played with a delay
corresponding to the value entered.
Note
If the channel is ganged with others, the same
operation is performed on all the ganged channels.
4.17.2 H
OW TO
P
LAY A
T
RAIN WITH A
D
ELAY
You can define a delay on a train in two different ways:
• Position the position indicator on the jog bar at the requested
position from the current timecode and press Enter.
• Type a delay value in the right duration field and press
Enter.