beautypg.com

Default clip duration, Open save window, Create clips on all synchronised recorders – EVS IPDirector Version 4.3 - October 2007 Part 3 User's Manual User Manual

Page 87: Automatic clip creation based on logs, Default xt for partial clip restore

background image

Issue 4.3.C

IP Director Version 4.3 – User Manual – Part 3: Ingest and Play-Out

EVS Broadcast Equipment

74

D

EFAULT

C

LIP

D

URATION

The default clip duration makes it possible to create a new clip

with the default duration specified in this setting when only the
IN point or the OUT point has been defined.

O

PEN

S

AVE

W

INDOW

If this setting is NOT checked, the clip will be made instantly
when the New Clip button is selected in the Control Panel. The
clip is stored in the next available location on the page

designated for IP Director Clips in the XT setup (default setting
is page 6). Please refer to the XT Set up for IP Director appendix
for more information.

If this setting is checked, the Save Clip window will open when
the New Clip button is selected in the Control Panel. The user
can enter data on the clip in this window.

C

REATE

C

LIPS ON

A

LL

S

YNCHRONISED

R

ECORDERS

When this setting is selected, clips will automatically be created
on all ganged recorders of the recorder on which the user
creates a clip.

The clip that the user has created will have the extension 00
after the name and the clips created on the ganged recorders

will have extension 01, 02, etc. depending on the number of
ganged recorders.

A

UTOMATIC

C

LIP

C

REATION BASED ON

L

OGS

The automatic clip creation based on the logs allows for a clip to
be created around a captured timecode on a Log Sheet using the
parameters defined in this setting.

If the Pre Mark and Post Mark are set to 5 sec, which are the
default values, the clip that will be created will have an IN point
5 seconds before the log timecode and an OUT point 5 seconds
after the log timecode.

For more information on the creation of automatic clips, refer to

section “How to Make Automatic Clips Based on a Logged
Event”, in the Database Explorer chapter.

D

EFAULT

XT

FOR

P

ARTIAL

C

LIP

R

ESTORE

This setting allows the user to define the XT server where to
store the sub clips that will be created based on clips published
on an XFile.