EVS IPDirector Version 4.3 - October 2007 Part 3 User's Manual - Manual (Page 68)

IP Director Version 4.3 – User Manual – Part 3: Ingest and Play-Out
EVS Broadcast Equipment Issue 4.3.C
55
4.7.2 C
LIP
L
OCATION
The user can enter a valid and free location, i.e. LSM ID, where
the clip should be stored.
If the specified LSM ID is not free, the clip will not be created
and an error message will be displayed in the message bar. This
also means the user will have to redefine all IN, OUT and other
metadata fields again.
If no number is entered, the clip will be stored in the next
available location on the page designated for IP Director clips in
the XT setup.
Note
In IPDP Spotbox modes, it is not possible to change the
“protocol receive page” as mentioned above. In this
configuration, the system will obey the previous LSM
mode setting the user has defined.
4.7.3 C
LIP
N
AME
The Clip name can contain up to 24 alphanumeric characters.
Only 12 characters of this name can be displayed by LSM
systems.