3Com WX4400 3CRWX440095A - Manual (Page 630)

630 C HAPTER A: T ROUBLESHOOTING A WX S WITCH
Mark messages are disabled by default. When they are enabled, MSS
generates a message at the notice level once every 300 seconds by
default.
To enable mark messages, use the following command:
WX4400# set log mark enable
success: change accepted.
Saving Trace Messages in a File
To save the accumulated trace data for enabled traces to a file in the WX
switch’s nonvolatile storage, use the following command:
save trace filename
To save trace data into the file trace1 in the subdirectory traces, type the
following command:
WX1200# save trace traces/trace1
Displaying the Log Configuration
To display your current log configuration, type the following command:
WX1200# display log config
Logging console:
enabled
Logging console severity: INFO
Logging sessions: enabled
Logging sessions severity: INFO
Logging buffer: enabled
Logging buffer severity: ERROR
Logging buffer size: 400 messages
Logging trace: enabled
Logging trace severity: DEBUG
Logging buffer size: 1048576 bytes
Log marking: disabled
Log marking severity: NOTICE
Log marking interval: 300 seconds
Logging server:
172.21.12.19 port 514 severity
EMERGENCY
severity CRITICAL
Current session:
disabled
Current session severity: INFO