3Com WX4400 3CRWX440095A - Manual (Page 254)

254 C HAPTER 10: C ONFIGURING MAP A CCESS P OINTS
To enable local switching for MAP 7, type the following command:
WX# set ap 7 local-switching mode enable
success: change accepted.
Applying a VLAN Profile to a MAP
To apply a VLAN profile to a MAP to use with local switching, use the
following
command:
set ap apnumber local-switching vlan-profile profile-name
When a VLAN profile is applied to a MAP, traffic for the VLANs specified
in the VLAN profile is locally switched by the MAP instead of being
tunneled back to a
WX switch.
If local switching is enabled on a MAP, but no VLAN profile is
configured, then a default VLAN profile is used. The default VLAN
profile includes a single VLAN named default that is not tagged
.
When applying a VLAN profile causes traffic that had been tunneled to a
WX switch to be locally switched by MAPs, or vice-versa, the sessions of
clients associated with the MAPs where the VLAN profile is applied are
terminated, and the clients must re-associate with the MAPs.
To specify that MAP 7 use VLAN profile locals, type the following
command:
WX# set ap 7 local-switching vlan-profile locals
success: change accepted.
Clearing the VLAN Profile from a MAP
To clear the VLAN profile that had been applied to a MAP, use the
following
command:
clear ap ap-number local-switching vlan-profile
When the VLAN profile is cleared from the MAP, traffic that had been
locally switched is tunneled to a WX switch.
When clearing a VLAN profile causes traffic that had been locally
switched by MAPs to be tunneled to a WX switch, the sessions of clients
associated with the MAPs where the VLAN profile is applied are
terminated, and the clients must re-associate with the MAPs.