3Com WX4400 3CRWX440095A User Manual
Page 102
102
C
HAPTER
5: C
ONFIGURING
AND
M
ANAGING
P
ORTS
AND
VLAN
S
4 Configure ports 5 and 6 as wired authentication ports and verify the
configuration change. Type the following commands:
WX1200# set port type wired-auth 5,6
success: change accepted
WX1200# display port status
Port Name
Admin Oper
Config
Actual
Type
Media
===============================================================================
1
mgmt
up
up
auto
100/full
network
10/100BaseTx
2
finance
up
up
auto
100/full
ap
10/100BaseTx
3
accounting
up
up
auto
100/full
ap
10/100BaseTx
4
shipping
up
up
auto
100/full
ap
10/100BaseTx
5
lobby
up
up
auto
100/full
wired auth 10/100BaseTx
6
lobby
up
up
auto
100/full
wired auth 10/100BaseTx
7
conf_room1
up
up
auto
100/full
network
10/100BaseTx
8
conf_room1
up
up
auto
100/full
network
10/100BaseTx
5 Configure ports 7 and 8 as a load-sharing port group to provide a
redundant link to the backbone, and verify the configuration change.
Type the following commands:
WX1200# set port-group name backbonelink port 7,8 mode on
success: change accepted.
WX1200# display port-group
Port group: backbonelink is up
Ports: 7, 8
6 Add port 1 to the default VLAN (VLAN 1) and verify the configuration
change. Type the following commands:
WX1200# set vlan default port 1
success: change accepted.
WX1200# display vlan config
Admin VLAN Tunl
Port
VLAN Name
Status State Affin Port
Tag
State
---- ---------------- ------ ----- ----- ---------------- ----- -----
1 default
Up
Up
5
1
none Up
4094 web-aaa Up Up 0
2 4094 Up
7 Save the configuration. Type the following command:
WX1200# save config
success: configuration saved.