3Com WX4400 3CRWX440095A - Manual (Page 346)

346 C HAPTER 16: C ONFIGURING Q UALITY OF S ERVICE
Tune Power Interval: 600 Channel Holddown: 300
Power Backoff Timer: 10 Countermeasures: none
Active-Scan: yes QoS Mode: wmm
Service profiles: sp1
In this example, the QoS mode is WMM.
(For more information about this command’s output, see the “MAP
Commands” chapter in the
Wireless LAN Switch and Controller
Configuration Guide .)
Displaying a Service
Profile’s QoS Settings
To display QoS settings and all other settings for a service profile, use the
following command:
display service-profile {name | ?}
The following example shows the configuration of the sp1 service profile.
WX1200# display service-profile sp1
ssid-name:
corp2 ssid-type: crypto
Beacon: yes Proxy ARP: no
DHCP restrict: no No broadcast: no
Short retry limit: 5 Long retry limit: 5
Auth fallthru: none Sygate On-Demand (SODA): no
Enforce SODA checks: yes SODA remediation ACL:
Custom success web-page: Custom failure web-page:
Custom logout web-page: Custom agent-directory:
Static COS: no COS: 0
CAC mode:
session CAC sessions: 14
User idle timeout: 180 Idle client probing: yes
Web Portal Session Timeout: 5
WEP Key 1 value: WEP Key 2 value:
WEP Key 3 value: WEP Key 4 value:
WEP Unicast Index: 1 WEP Multicast Index: 1
Shared Key Auth: NO
WPA enabled:
ciphers: cipher-tkip
authentication: 802.1X
TKIP countermeasures time: 60000ms
11a beacon rate: 6.0 multicast rate: AUTO
11a mandatory rate: 6.0,12.0,24.0 standard rates: 9.0,18.0,36.0,48.0,54.0
11b beacon rate: 2.0 multicast rate: AUTO
11b mandatory rate: 1.0,2.0 standard rates: 5.5,11.0
11g beacon rate: 2.0 multicast rate: AUTO
11g mandatory rate: 1.0,2.0,5.5,11.0 standard rates: 6.0,9.0,12.0,18.0,24.0,
36.0,48.0,54.0