3Com WX4400 3CRWX440095A - Manual (Page 316)

316 C HAPTER 14: C ONFIGURING RF A UTO -T UNING
Changing
RF Auto-Tuning
Settings You can change the following RF Auto-Tuning settings:
„
Channel tuning
„
Power tuning
„
Minimum transport data rate
Selecting Available
Channels on the
802.11a Radio
You can configure the 802.11a radio on a MAP to allow certain channels
to be available or unavailable. To enable this feature, use the following
command:
set radio-profile name auto-tune 11a-channel-range
{lower-bands | all bands}
If you select lower-bands , MSS selects a channel from the lower eight
bands in the 802.11a range of channels: 36, 40, 44, 48, 52, 56, 60, or
64.
If you select all-bands , MSS selects a channel from the entire 802.11a
range of channels: 36, 40, 44, 48, 52, 60, 64, 149, 153, 157, or 161.
Changing Channel
Tuning Settings
Disabling or Reenabling Channel Tuning
RF Auto-Tuning for channels is enabled by default. To disable or reenable
the feature for all radios in a radio profile, use the following command:
set radio-profile name auto-tune channel-config
{enable | disable} [ignore-clients]
The ignore-clients option allows MSS to change the channel on a radio
even if the radio has active client sessions. Without this option, MSS does
not change the channel unless there are no active client sessions on the
radio.
To disable channel tuning for radios in the rp2 radio profile, type the
following command:
WX1200# set radio-profile rp2 auto-tune channel-config
disable
success: change accepted.