3Com WX4400 3CRWX440095A - Manual (Page 318)

318 C HAPTER 14: C ONFIGURING RF A UTO -T UNING
Changing the Power Tuning Interval
The default power tuning interval is 600 seconds. You can change the
interval to a value from 1 to 65535 seconds. To change the power tuning
interval, use the following command:
set radio-profile name auto-tune power-interval seconds
To set the power tuning interval for radios in radio profile rp2 to 240
seconds, type the following command:
WX1200# set radio-profile rp2 auto-tune power-interval 240
success: change accepted.
Changing the Maximum Default Power Allowed On a Radio
By default, the maximum power level that RF Auto-Tuning can set on a
radio is the same as the maximum power level allowed for the country of
operation. To change the maximum power level that RF Auto-Tuning can
assign, use the following command:
set ap apnumber radio {1 | 2} auto-tune max-power power-level
The power-level can be a value from 1 to 20.
To set the maximum power that RF Auto-Tuning can set on radio 1 on
the MAP on port 6 to 12 dBm, type the following command.
WX1200# set ap 6 radio 1 auto-tune max-power 12
success: change accepted.
Locking Down
Tuned Settings You can convert dynamically assigned channels and power settings into
statically configured settings, by locking them down. When you lock
down channel or power settings, MSS converts the latest values set by RF
Auto-Tuning into static settings.
You can lock down channel or power settings on a radio-profile basis.
MSS implements the lock down by changing the set {ap | dap} radio
channel or set {ap | dap} radio tx-power command for each radio
managed by the radio profile
.
To lock down channel or power settings, use the following commands:
set radio-profile name auto-tune channel-lockdown
set radio-profile name auto-tune power-lockdown