3Com WX4400 3CRWX440095A - Manual (Page 172)

172 C HAPTER 9: C ONFIGURING N ETWORK D OMAINS
To specify 10.8.107.1 as an additional Network Domain seed for the WX
switch to connect to if the 192.168.9.254 seed is unavailable, enter the
following command:
WX1200# set network-domain mode member seed-ip 10.8.107.1
affinity 2
success: change accepted.
Displaying Network
Domain Information
To view the status of Network Domains configured on the WX switch, use
the display network-domain command. The output of the command
differs based on whether the WX switch is a member of a Network
Domain or a Network Domain seed.
For example, a WXswitch that is a Network Domain member only, output
such as the following is displayed:
WX4400# display network-domain
Member Network Domain name: California
Member State Mode
--------------- ------------- ------
10.67.1.201
UP MEMBER
10.67.1.200 UP SEED
On a WX switch that is a Network Domain seed, information is displayed
about the Network Domain seeds with which the WX switch has a peer
relationship, as well as the Network Domains of which the WX switch is a
member. For example:
WX4400# display network-domain
Network Domain name: California
Peer State
--------------- -------------
10.67.1.200
UP
Member State Mode
--------------- ------------- ------
10.67.1.201
UP MEMBER
(For more information about this command and the fields in the output,
see the
Wireless LAN Switch and Controller Command Reference .)