3Com WX4400 3CRWX440095A - Manual (Page 173)

Configuring a Network Domain 173
Clearing Network
Domain
Configuration from a
WX Switch
You can clear all Network Domain configuration from a WX switch,
regardless of whether the WX switch is a seed or a member of a Network
Domain. You may want to do this in order to change a WX switch from
one Network Domain to another, or to remove a WX switch entirely from
a Network Domain.
To clear the Network Domain configuration from the WX switch, type the
following command:
clear network-domain
This command has no effect if the WX switch is not configured as part of
a Network Domain.
Clearing a Network
Domain Seed from a
WX Switch
You can remove individual Network Domain seeds from a WX switch’s
configuration. To remove a specific Network Domain seed, type the
following command:
clear network-domain seed-ip ip-addr
When you enter this command, the Network Domain TCP connections
between the WX switch and the specified Network Domain seed are
closed.
Clearing a Network
Domain Peer from a
Network Domain
Seed
On a WX switch configured as a Network Domain seed, you can clear the
configuration of individual Network Domain peers. To remove a specific
Network Domain peer from a Network Domain seed, type the following
command:
clear network-domain peer ip-addr
This command has no effect if the WX switch is not configured as a
Network Domain seed.
Clearing Network
Domain Seed or
Member
Configuration from a
WX Switch
You can remove the Network Domain seed or member configuration
from the WX switch. To do this, enter the following command:
clear network-domain mode {seed | member}
Use the seed parameter to clear Network Domain seed configuration
from the WX switch. Use the member parameter to clear Network
Domain member configuration from the WX switch.