3Com WX4400 3CRWX440095A - Manual (Page 477)

Configuring Web Portal WebAAA 477
5 Commit the new ACL to the configuration, using the following
command:
commit security acl
6 Change the Web-Portal ACL name set on the service profile, using the
following command:
set service-profile name web-portal-acl aclname
7 Verify the change by displaying the service profile.
8 Save the configuration changes.
Configuring the Web
Portal WebAAA
Session Timeout
Period
When a client that has connected through Web Portal WebAAA enters
standby or hibernation mode, MSS may place the client’s Web Portal
WebAAA session in the Deassociated state.
A Web Portal WebAAA session can be placed in the Deassociated state
under the following circumstances:
„
The client has been idle for the User idle-timeout period, which can
happen when the client is in standby or hibernation mode
„
The client explicitly deassociates from the MAP by sending an 802.11
disassociate message
„
The MAP handling the client's session appears to be inoperative from
the WX switch
When a Web Portal WebAAA session enters the Deassociated state, it
stays in that state until one of the following takes place:
„
The client reappears on this MAP or another MAP managed by a WX
switch, at which time the Web Portal WebAAA session enters the
Active state
„
The Web Portal WebAAA session is terminated administratively
„
The Web Portal WebAAA session timeout period expires, at which
time the Web Portal WebAAA session is terminated automatically
By default, the Web Portal WebAAA session timeout period is 5 seconds.
You can optionally change the length of the Web Portal WebAAA Session
Timeout period. This can be useful if you want to allow a client
connecting through Web Portal WebAAA to enter standby or hibernation
mode, then be able to resume its session after waking up, without having
to log in again.