3Com WX4400 3CRWX440095A - Manual (Page 212)

212 C HAPTER 10: C ONFIGURING MAP A CCESS P OINTS
Although these parameters have default values, 3Com recommends that
you change the values for each radio for optimal performance. For
example, leaving the channel number on each radio set to its default
value can result in high interference among the radios.
(To configure these parameters, see “Configuring Radio-Specific
Parameters” on page 246.)
antennatype For most MAP models, the
default is internal.
For MP-620, the default for the
802.11b/g radio is
ANT-1360-OUT. The default for
the 802.11a radio is
ANT-5360-OUT.
The default for the 802.11b/g
radio on model MP-262 is
ANT1060.
3Com external antenna model
This parameter is configurable
only on MAPs that support
external antennas.
auto-tune
max-power Highest setting allowed for the
country of operation or highest
setting supported on the
hardware, whichever is lower Maximum percentage of client
retransmissions a radio can
experience before RF
Auto-Tuning considers changing
the channel on the radio.
(To configure RF Auto-Tuning,
see “Configuring
RF Auto-Tuning” on page 311.)
channel
„
802.11b/g — 6
„
802.11a — Lowest valid
channel number for the
country of operation
Number of the channel in which
a radio transmits and receives
traffic
mode disable Operational state of the radio.
radio-profile None. You must add the radios
to a radio profile. 802.11 settings
tx-power Highest setting allowed for the
country of operation or highest
setting supported on the
hardware, whichever is lower. Transmit power of a radio, in
decibels referred to 1 milliwatt
(dBm)
Table 13 Radio-Specific Parameters (continued)
Parameter Default Value Description