3Com WX4400 3CRWX440095A - Manual (Page 251)

Disabling or Reenabling Radios 251
Resetting a Radio to
its Factory Default
Settings
To disable a MAP radio and reset it to its factory default settings, use the
following command:
clear ap apnumber radio {1 | 2 | all}
This command performs the following actions:
„
Sets the transmit power, channel, and external antenna type to their
default values.
„
Removes the radio from its radio profile and places the radio in the
default radio profile.
This command does not affect the PoE setting.
To disable and reset radio 2 on the MAP connected to port 3, type the
following command:
WX1200# clear ap 3 radio 2
Restarting a MAP To restart a MAP, use the following command:
reset ap apnumber
Use the reset ap command to reset a MAP configured on a MAP access
port. Use the reset ap command to reset a Distributed MAP.
When you enter one of these commands, the MAP drops all sessions and reboots.
Restarting a MAP can cause data loss for users who are currently
associated with the MAP.