Displaying service profile information – 3Com WX4400 3CRWX440095A User Manual
Page 259
Displaying MAP Information
259
The WX does not need to be the one that booted the MAP, but it must
have the MAP in its configuration. Also, the WX that booted the MAP
must be in the same Mobility Domain as the WX where you use the
command.
Displaying Service
Profile Information
To display service profile information, use the following command:
display service-profile {name | ?}
Entering display service-profile ? displays a list of the service profiles
configured on the switch.
To display information for service profile sp1, type the following
command:
WX# display service-profile sp1
ssid-name:
corp2
ssid-type:
crypto
Beacon:
yes
Proxy ARP:
no
DHCP restrict:
no
No broadcast:
no
Short retry limit:
5
Long retry limit:
5
Auth fallthru:
none
Sygate On-Demand (SODA):
no
Enforce SODA checks:
yes
SODA remediation ACL:
Custom success web-page:
Custom failure web-page:
Custom logout web-page:
Custom agent-directory:
Static COS:
no
COS:
0
CAC mode:
none
CAC sessions:
14
User idle timeout:
180
Idle client probing:
yes
Keep initial vlan:
no
Web Portal Session Timeout:
5
Web Portal ACL:
WEP Key 1 value:
WEP Key 2 value:
WEP Key 3 value:
WEP Key 4 value:
WEP Unicast Index:
1
WEP Multicast Index:
1
Shared Key Auth:
NO
WPA enabled:
ciphers: cipher-tkip
authentication: 802.1X
TKIP countermeasures time: 60000ms
vlan-name = orange
session-timeout = 300
service-type = 2
11a beacon rate:
6.0
multicast rate:
AUTO
11a mandatory rate: 6.0,12.0,24.0 standard rates: 9.0,18.0,36.0,48.0,54.0
11b beacon rate:
2.0
multicast rate:
AUTO
11b mandatory rate: 1.0,2.0 standard rates: 5.5,11.0
11g beacon rate:
2.0
multicast rate:
AUTO