3Com WX4400 3CRWX440095A - Manual (Page 261)

Displaying MAP Information 261
The following command displays the status of a Distributed MAP:
WX# display ap status 1
AP: 7, AP model: AP3750, manufacturer 3Com, name: MAP07
====================================================
State: operational
(not encrypt)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr, ram=33554432
s/n=0333703050 hw_rev=A3
Uptime: 531 hours, 37 minutes, 28 seconds
Radio 1 type: 802.11g, state: configure succeed [Disabled] (Sweep mode)
operational channel: 1 (Auto) operational power: 1
bssid1: 00:0b:0e:00:ca:c0, ssid: techpubs
bssid2: 00:0b:0e:00:ca:c2, ssid: techpubs-wpa
load balance: enabled, current load: (unavailable)
RFID Reports: Inactive
Radio 2 type: 802.11a, state: configure succeed [Disabled] (Sweep mode)
operational channel: 40 (Auto) operational power: 1
bssid1: 00:0b:0e:00:ca:c1, ssid: chloe
load balance: enabled, current load: (unavailable)
RFID Reports: Inactive
(For information about the fields in the output, see the Wireless LAN
Switch and Controller Command Reference .)
Displaying Static IP
Address Information
for Distributed MAPs
To display information about Distributed MAPs that have been
configured with static IP address information, use the following
command:
display ap boot-configuration apnumber
To display statistics counters for Distributed MAP 1, type the following
command:
WX# display ap boot-configuration 1
Static Boot Configuration
AP: 7
IP Address: Disabled
VLAN Tag:
Disabled
Switch: Disabled
Mesh: Disabled
IP Address:
Netmask:
Gateway:
VLAN Tag:
Switch IP:
Switch Name: