3Com WX4400 3CRWX440095A - Manual (Page 107)

Configuring and Managing IP Interfaces 107
Displaying DHCP Client Information To display DHCP client
information, type the following command:
WX1200# display dhcp-client
Interface: corpvlan(4)
Configuration Status: Enabled
DHCP State: IF_UP
Lease Allocation: 65535 seconds
Lease Remaining: 65532 seconds
IP Address: 10.3.1.110
Subnet Mask: 255.255.255.0
Default Gateway: 10.3.1.1
DHCP Server: 10.3.1.4
DNS Servers: 10.3.1.29
DNS Domain Name: mycorp.com
Disabling or
Reenabling an IP
Interface
IP interfaces are enabled by default. To administratively disable or
reenable an IP interface, use the following command:
set interface vlan-id status {up | down}
Removing an IP
Interface
To remove an IP interface, use the following command:
clear interface vlan-id ip
CAUTION: If you remove the IP interface that is being used as the system
IP address, features that require the system IP address will not work
correctly.
Displaying IP
Interface Information
To display IP interface information, use the following command:
display interface [vlan-id]