3Com WX4400 3CRWX440095A User Manual
Page 305
Encryption Configuration Scenarios
305
TKIP is already enabled by default when WPA is enabled.
6 Display the service profile wpa-wep to verify the changes. Type the
following command:
WX1200# display service-profile sp1
ssid-name: mycorp ssid-type: crypto
Beacon: yes Proxy ARP: no
DHCP restrict: no No broadcast: no
Short retry limit: 5 Long retry limit: 5
Auth fallthru: none Sygate On-Demand (SODA): no
Enforce SODA checks: yes SODA remediation ACL:
Custom success web-page: Custom failure web-page:
Custom logout web-page: Custom agent-directory:
Static COS: no COS: 0
CAC mode: none CAC sessions: 14
User idle timeout: 180 Idle client probing: yes
Keep initial vlan:
no
Web Portal Session Timeout:
5
Web Portal ACL:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index: 1 WEP Multicast Index: 1
Shared Key Auth: NO
WPA enabled:
ciphers: cipher-tkip, cipher-wep40
authentication: 802.1X
TKIP countermeasures time: 60000ms
...
7 Map service profile wpa-wep to radio profile rp2. Type the following
commands:
WX1200# set radio-profile rp2 service-profile wpa-wep
success: change accepted.
8 Apply radio profile rp2 to radio 1 on port 5 and to radios 1 and 2 on
port 6, enable the radios, and verify the configuration changes. Type the
following commands:
WX1200# set ap 5,6 radio 1 radio-profile rp2 mode enable
success: change accepted.
WX1200# set ap 6 radio 2 radio-profile rp2 mode enable
success: change accepted.
WX1200# display ap config
Port 5: AP model: mp-241, POE: enable, bias: high, name: MAP05
boot-download-enable: YES
force-image-download: YES
Radio 1: type: 802.11a, mode: enabled, channel: 36
tx pwr: 1, profile: rp2