3Com WX4400 3CRWX440095A - Manual (Page 512)

512 C HAPTER 21: C ONFIGURING AAA FOR N ETWORK U SERS
Network User
Configuration
Scenarios The following scenarios provide examples of ways in which you use AAA
commands to configure access for users:
„
“General Use of Network User Commands” on page 512
„
“Enabling RADIUS Pass-Through Authentication” on page 514
„
“Enabling PEAP-MS-CHAP-V2 Authentication” on page 514
„
“Enabling PEAP-MS-CHAP-V2 Offload” on page 515
„
“Combining EAP Offload with Pass-Through Authentication” on
page 516
„
“Overriding AAA-Assigned VLANs” on page 516
General Use of
Network User
Commands
The following example illustrates how to configure IEEE 802.1X network
users for authentication, accounting, ACL filtering, and Mobility Profile
assignment:
1 Configure all 802.1X users of SSID mycorp at EXAMPLE to be
authenticated by server group shorebirds. Type the following command:
WX1200# set authentication dot1x ssid mycorp EXAMPLE\* pass-through shorebirds
2 Configure stop-only accounting for all mycorp users at EXAMPLE, for
accounting records to be stored locally. Type the following command:
WX1200# set accounting dot1x ssid mycorp EXAMPLE\* stop-only local
success: change accepted.
3 Configure an ACL to filter the inbound packets for each user at
EXAMPLE. Type the following command for each user: <>
WX1200# set user EXAMPLE\username attr filter-id = acl-101.in
This command applies the access list named acl-101 to each user at
EXAMPLE.
4 To display the ACL, type the following command:
WX1200# display security acl info acl-101
set security acl ip acl-101 (hits #0 0)
----------------------------------------------------
1. permit IP source IP 192.168.1.1 0.0.0.255 destination IP any enable-hits
(For more information about ACLs, see Chapter 19, “Configuring and
Managing Security ACLs,” on page 377.)