3Com WX4400 3CRWX440095A - Manual (Page 393)

Mapping Security ACLs 393
To display a summary of the security ACLs mapped on a MAP (in this
example, MAP 7), type the following command:
WX# display ap acl map 7
ACL
Type Class Mapping
---------------------------- ---- ------ -------
acl_123
IP Static In
acl_133 IP Static In
acl_124 IP Static
Clearing a Security ACL Map
To clear the mapping between a security ACL and one or more ports,
VLANs, virtual ports, or Distributed MAPS, first display the mapping with
display security acl map and then use clear security acl map to
remove it. This command removes the mapping, but not the ACL.
For example, to clear the security ACL acljoe from a port, type the
following commands:
WX1200# display security acl map acljoe
ACL acljoe is mapped to:
Port 4 In
WX1200# clear security acl map acljoe port 4 in
success: change accepted.
After you clear the mapping between port 4 and ACL acljoe, the
following is displayed when you enter display security acl map:
WX1200# display security acl map acljoe
ACL acljoe is mapped to:
Clearing a security ACL mapping does not stop the current filtering
function if the ACL has other mappings. If the security ACL is mapped to
another port, a VLAN, a virtual port, or a Distributed MAP, you must enter
a clear security acl map command to clear each map.
To stop the packet filtering of a user-based security ACL, you must modify
the user’s configuration in the local database on the WX switch or on the
RADIUS servers where packet filters are authorized. For information
about deleting a security ACL from a user’s configuration in the local WX
database, see “Clearing a Security ACL from a User or Group” on
page 495. To delete a security ACL from a user’s configuration on a
RADIUS server, see the documentation for your RADIUS server.