3Com WX4400 3CRWX440095A - Manual (Page 319)

Displaying RF Auto-Tuning Information 319
To verify the static settings, use the display {ap | dap} config command.
To save the locked down settings, you must save the switch’s configuration.
The following commands lock down the channel and power settings for
radios in radio profile rp2:
WX1200# set radio-profile rp2 auto-tune channel-lockdown
success: change accepted.
WX1200# set radio-profile rp2 auto-tune power-lockdown
success: change accepted.
Displaying
RF Auto-Tuning
Information You can display the RF Auto-Tuning configuration, a list of RF neighbors,
and the values of RF attributes.
(For information about the fields in the output, see the Wireless LAN
Switch and Controller Command Reference .)
Displaying
RF Auto-Tuning
Settings
To display the RF Auto-Tuning settings that you can configure in a radio
profile, use the following command:
display radio-profile {name | ?}
Entering display radio-profile ? displays a list of radio profiles.
To display the RF Auto-Tuning and other settings in the default radio
profile, type the following command:
WX# display radio-profile default
Beacon Interval: 100 DTIM Interval: 1
Max Tx Lifetime: 2000 Max Rx Lifetime: 2000
RTS Threshold: 2346 Frag Threshold: 2346
Long Preamble: no Tune Channel: yes
Tune Channel Range (11a): lower-bands Ignore Clients: no
Tune Power: no Tune Channel Interval: 3600
Tune Power Interval: 600 Power ramp interval: 60
Channel Holddown: 300 Countermeasures: none
Active-Scan: yes RFID enabled: no
WMM Powersave: no QoS Mode: wmm
Rate Enforcement: no Initial Load: 1000
ETT Link Factor: 3 Change Threshold: 25
Dwell Time: 3600 Probe Interval: 60
Intial Measur Interval: 60 Maximum Measure Interval: 600
Radio Link Timeout: 5