3Com WX4400 3CRWX440095A - Manual (Page 290)

290 C HAPTER 13: C ONFIGURING U SER E NCRYPTION
Table 24 lists the encryption support for WPA and non-WPA clients.
Configuring WPA To configure MAP radios to support WPA:
1 Create a service profile for each SSID that will support WPA clients.
2 Enable the WPA IE in the service profile.
3 Enable the cipher suites you want to support in the service profile. (TKIP is
enabled by default.) Optionally, you also can change the countermeasures
timer value for TKIP.
4 Map the service profile to the radio profile that will control IEEE settings
for the radios.
5 Assign the radio profile to the radios and enable the radios.
If you plan to use PSK authentication, you also need to enable this
authentication method and enter an ASCII passphrase or a hexadecimal
(raw) key.
Table 24 Encryption Support for WPA and Non-WPA Clients
MSS
Encryption
Type
Client Encryption Type
WPA —
CCMP WPA —
TKIP WPA —
WEP40 WPA —
WEP104 Dynamic
WEP Static
WEP
WPA —
CCMP Supports
WPA —
TKIP Supports
WPA —
WEP40
Supports Supports
WPA —
WEP104 Supports Supports Supports
Dynamic
WEP Supports
Static
WEP
Supports