3Com WX4400 3CRWX440095A - Manual (Page 221)

Configuring MAPs 221
MAPs that receive their configurations from the Auto-AP profile also
receive the radio settings from the radio profile used by the Auto-AP
profile. Likewise, the SSIDs and encryption settings come from the service
profiles mapped to the radio profile. To use a radio profile other than
default, you must specify the radio profile you want to use. (See
“Specifying the Radio Profile Used by the Auto-AP Profile” on page 222.)
Changing MAP Parameter Values The commands for configuring
MAP and radio parameters for the Auto-AP profile are the same as the
commands for configuring an individual Distributed MAP. Instead of
specifying a Distributed MAP number with the command, specify auto.
For more information about the syntax, see the “MAP Commands”
chapter of the
Wireless LAN Switch and Controller Command Reference .
Table 16 Configurable Profile Parameters for Distributed MAPs
Parameter Default Value
MAP Parameters
bias high
blink
(Not shown in display ap config
output)
disable
force-image download disable (NO)
group (load balancing group) none
mode disabled
persistent none
upgrade-firmware
(boot-download-enable) enable (YES)
Radio Parameters
radio num auto-tune max-power default
radio num mode enabled
radio num radio-profile default
radiotype 11g
(or 11b for country codes where
802.11g is not allowed)