3Com WX4400 3CRWX440095A - Manual (Page 320)

320 C HAPTER 14: C ONFIGURING RF A UTO -T UNING
To display the RF Auto-Tuning settings that you can configure on an
individual radio, use the following commands:
display ap config [port-list [radio {1 | 2}]]
display ap config [ap-num [radio {1 | 2}]]
To display the RF Auto-Tuning and other individual radio settings on radio
1 of a directly connected MAP connected to WX port 2, type the
following command:
WX# display ap config 2 radio 1
Port 2: AP model: mp-352, POE: enabled, bias: high, name:
MAP02
boot-downloaded-enable: YES
force-image-download: NO
Radio 1: type: 802.11g, mode: disabled, channel: 5
tx pwr: 1, profile: default
auto-tune max-power: default
To display the RF Auto-Tuning and other individual radio settings on both
radios
on the MAP access point configured on connection 1, type the
following command:
WX# display ap config 1
Dap 1: serial-id: 12345678, AP model: mp-352, bias: high, name: DAP01
fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
boot-download-enable: YES
force-image-download: NO
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 1, profile: default
auto-tune max-power: default
Radio 2: type: 802.11a, mode: disabled, channel: 36
tx pwr: 1, profile: default
auto-tune max-power: default
Displaying RF
Neighbors
To display the other radios that a specific 3Com radio can hear, use the
following commands:
display auto-tune neighbors [ap map-num [radio {1 | 2| all}]]
display auto-tune neighbors
[ap ap-num [radio {1 | 2 | all}]
The list of radios includes beaconed third-party SSIDs, and both beaconed
and unbeaconed 3Com SSIDs.