3Com WX4400 3CRWX440095A User Manual
Page 257
Displaying MAP Information
257
force-rebalance: NO,
Radio 2: type: 802.11a, mode: disabled, channel: dynamic
tx pwr: 17, profile: default
auto-tune max-power: default,
load-balance-group: ,
load-balance-enable: YES,
force-rebalance: NO,
local-switching: enabled, vlan-profile: locals
(For information about the fields in the output, see the
Wireless LAN
Switch and Controller Command Reference
.)
Displaying
Connection
Information for
Distributed MAPs
To display connection information for Distributed MAPs configured on a
WX switch, use the following command:
display ap global [apnumber | serial-id serial-ID]
This command lists the System IP addresses of all the WX switches on
which each Distributed MAP is configured, and lists the bias for the MAP
on each switch. For each Distributed MAP that is configured on the
switch on which you use the command, the connection number is also
listed.
Connections are shown only for the Distributed MAPs that are configured
on the WX from which you enter the command, and only for the Mobility
Domain the WX is in.
To display connection information for all Distributed MAPs configured on
a WX switch, type the following command:
WX4400# display ap global
Total number of entries: 8
AP Serial Id
WX IP Address Bias
--- -----------
--------------- ----
1
M9DE48B012F00 10.3.8.111 HIGH
-
M9DE48B012F00 10.4.3.2 LOW
2
M9DE48B123400 10.3.8.111 LOW
-
M9DE48B123400 10.4.3.2 HIGH
17 M9DE48B123600 10.3.8.111 HIGH
-
M9DE48B123600 10.4.3.2 LOW
18 M9DE48B123700 10.3.8.111 LOW
-
M9DE48B123700 10.4.3.2 HIGH