3Com WX4400 3CRWX440095A - Manual (Page 183)

MAP Overview 183
MAP Parameters
Table 9 summarizes parameters that apply to individual MAPs, including
dual-homing parameters. (For information about parameters for
individual radios, see “Configuring a Radio Profile” on page 240 and
“Configuring Radio-Specific Parameters” on page 246.)
Table 9 Global MAP Parameters
Parameter Default value Description
name Based on the port or
Distributed MAP connection
number. For example:
„
MAP01
„
DAP01
MAP name.
bias high Setting a MAP’s bias on a
WX switch to high causes the
switch to be preferred over
switches with low bias, for
booting and managing the
MAP.
Note: Bias applies only to
WX switches that are
indirectly attached to the
MAP through an
intermediate Layer 2 or Layer
3 network. A MAP always
attempts to boot on MAP
port 1 first, and if a WX
switch is directly attached on
MAP port 1, the MAP boots
from it regardless of the bias
settings.
group None Named set of MAPs. MSS
load-balances user sessions
among the access points in
the group.
upgrade-firmware enable Automatic upgrade of boot
firmware.
blink disable LED blink mode — blinking
11a LED (AP2750) or health
and radio LEDs (MAP-xxx)
make the MAP visually easy
to identify.