Xantrex Technology XDC - Manual (Page 64)

Operation
Front Panel Controls
62 Operating Manual for XDC Series Power Supply
6. PROT SET: Lets you view and set protection setpoints. (See “Set Output
Protection” on page 65.)
7. RECALL: Lets you apply stored power supply settings. (See “Recall Settings”
on page 79.)
8. EXIT: Lets you cancel an operation or leave Calibration mode or Auto
Sequence mode.
Menu
Navigation
Four keys allow you to access many functions available on the menu. These keys are
MENU, ENTER, and the Up and Down arrow keys.
Top Level
Menu Items
To display the first menu item, press MENU. To display the other top level menu
items in the order listed below, press MENU or the Down arrow repeatedly. To
display the other items in reverse order, press the Up arrow repeatedly.
The top level menu items are:
1. ERROR MSGS: Lists up to 50 queued errors. (See “Read Error Messages” on
page 82.)
2. USER LINES: Configures auxiliary lines A and B. (See “Configure User
Lines” on page 83.)
3. PON CONFIG: Configures the power-on settings. (See “Configure Power ON
Settings” on page 84.)
4. S/D RECOVERY: Sets up shutdown recovery options for AC Off and
Over-Temperature Protection. (See “Set Shutdown Recovery for AC Off and
OTP” on page 71.)
5. REMOTE SELECT: Sets up the remote access option. (See “Select Remote
Control Source” on page 75.)
6. REMOTE CONFIG: Configures the remote access option. (See “Configure
Remote Control Source” on page 76.)
7. AUTO SEQ PGM: Programs automatic sequences. (See “Program Auto
Sequence” on page 87.)
8. CURRENT SHARE: Sets up master/slave relationships for multiple-supply
configurations. (See Section 5, “Current Sharing (6000 Watt only)”.)
9. POWER SETPT: Sets up the power output. (See “Set Power” on page 65.)
10. DISPLAY CFG: Sets up the display to show the desired combination of
voltage, current, and power. (See “Configure Display” on page 98.)