Xantrex Technology XDC - Manual (Page 214)

212
Operating Manual for
XDC Series Power Sup
ply
SCPI Command Re
fe
rence
SCPI C
omman
d Summary
Table B.15Legacy Commands
Notes:
All legacy commands that change a value conform to the same rules as SCPI. Commands will cause an error if the unit’s remote
source, remote state, current share mode status and calibration status is incorrect.
Legacy commands do not have multichannel capabilities.
Query commands return a string containing the command itself.
The “CLR” command does not clear any legacy fault registers.
The “RST” command only clears the protections so that the voltage and setpoints can take effect. It does not change any setpoint
values. When a protection is tripped the unit’s output may be turned off (configurable).
Function Legacy Command Description Query
Reset CLR Equivalent to *RST and SYSTem:RESet commands
Performs a device reset. Set the power supply to a known state that is independent of
the use history of the device N/A
Query System Error ERR? Equivalent to SYSTem:ERRor? command except that the return string contains the
command
Returns the next error in the instrument’s error queue N/A
Identification Query ID? Query identification string. (Model ID and Version) N/A
Read Output Current IOUT? Equivalent to MEASure:CURRent? command
Read output current N/A
Set High Current Limit IMAX Equivalent to SOURce:CURRent:LIMit:HIGH command.
Set upper limit of current setpoint range (soft limits) Yes
Set (Immediate) Current
Setpoint ISET Equivalent to SOURce:CURRent command.
Change current setpoint Yes
Set Output State OUT Equivalent to OUTP command.
Enable/disable the power supply output Yes
Set Over Voltage
Protection Level OVSET Equivalent to SOURce:VOLTage:PROTection:OVER:LEVel command.
Set the over voltage protection level Yes
ROM Query ROM? Queries the main firmware version N/A
Clear Output Protection RST Equivalent to OUTPut:PROTection:CLEar command.
Clears the protection mechanism N/A
Set High Voltage Limit VMAX Equivalent to SOURce:VOLTage:LIMit:HIGH command.
Set upper limit of voltage setpoint range (soft limits) Yes
Read Output Voltage VOUT? Equivalent to MEASure:VOLTage? command.
Read output voltage N/A
Set (Immediate) Voltage
Setpoint VSET Equivalent to SOURce:VOLTage command.
Change voltage setpoint Yes