Power on output state, Reset – Xantrex Technology XDC User Manual
Page 127
Remote Operation
SCPI Commands for Digital Interfaces
Release 3.0
125
Power On
Output State
You may also change the output state whether the output is enabled or disabled at
power on.
To change the power on at output state:
OUTP:PON:STAT [ON|OFF|1|0]
To check the setting:
OUTP:PON:STAT?
Reset
Resetting the unit puts certain features to a known state. These states are listed in the
table below.
To reset the unit:
*RST or SYST:RES
See also other documents in the category Xantrex Technology Tools:
- SW Plus 2548 (344 pages)
- XDC 60-100 (284 pages)
- RS232-XPD (60 pages)
- 230 VAC/50 (73 pages)
- XDC 20-300SL (36 pages)
- JAZZ 250 (36 pages)
- XPD 120-4.5 (56 pages)
- ACCB-L-L1 (64 pages)
- 250 (36 pages)
- 400R (74 pages)
- 40 A (XADC-40) (20 pages)
- XPR 40-150 (80 pages)
- GT100E (40 pages)
- C60 (114 pages)
- GPIB-M-XFR3 (134 pages)
- 600HD (64 pages)
- XTR600 (274 pages)
- XW POWER SYSTEM XW6048-120/240-60 (136 pages)
- GT3.0 (110 pages)
- 300 PLUS (64 pages)
- PV100S-208 (90 pages)
- PROwatt 600 (66 pages)
- 700 PLUS (52 pages)
- XDL 35-5TP (180 pages)
- C40R/100 Remote (34 pages)
- Powerpack 100 (53 pages)
- Powerpack 300 (61 pages)
- XPower Powerpack 400 R (82 pages)
- XDI2048 (92 pages)
- Solar 400 (66 pages)
- PV-225208 (47 pages)
- XPF 35-10 (40 pages)
- ACCB (66 pages)
- PROwatt 1000 (78 pages)
- XMP 2600 (119 pages)
- XFR 2800 (90 pages)