Xantrex Technology XDC User Manual
Page 161
Remote Operation
SCPI Commands for Digital Interfaces
Release 3.0
159
Service Request Enable Register
The Service Request Enable Register allows the user to select the reasons for the
power supply to issue a service request. The Service Request Enable Register allows
the user to select which summary messages in the Status Byte Register may cause
service requests.
To clear the Service Request Enable Register send "*SRE 0." The Power-on Status
Clear command also determines if the Service Request Enable Register is cleared at
power-on. A cleared register does not allow status information to generate a service
request.
E.g.
Sending "*SRE 8" sets bit 3 of the Service Request Enable Register. This will cause
the Summary bit of the Questionable Status register (bit 3) in the Status Byte to
generate a service request message whenever it gets set.
Command: *SRE
SCPI equivalent for multichannel use:
STATus[
STATus[
Parallel Poll Enable Register
Each of the 16 bits in the Parallel Poll Enable register correspond to bits in the Status
Byte. Each bit in the Parallel Poll Enable register is ANDed with its corresponding
bit in the Status Byte and the resulting bits are ORed together to generate ist.
Therefore using the parallel poll enable register allows any single bit or combination
of bits to control the ist message.
The Power-on Status Clear command determines if the Parallel Poll Enable Register
is cleared at power-on.
E.g.
Sending "*PRE 8" sets bit 3 of the Parallel Poll Enable Register. This will cause the
Summary bit of the Questionable Status register (bit 3) in the Status Byte to generate
a TRUE ist message whenever it gets set.
Command: *PRE