Xantrex Technology XDC - Manual (Page 38)

Installation
Returning Power Supplies to the Manufacturer
36 Operating Manual for XDC Series Power Supply
Packaging for
Shipping or
Storage
Follow these instructions to prepare the power supply for shipping or storage.
1. When returning the unit or sending it to the service center, attach a tag to the unit
stating its model number (located on the front panel label) and serial number
(located on the rear panel label). Give the date of purchase and an invoice
number, if you have it, as well as a brief description of the problem.
2. For storage and shipping, repack the power supply in its original container. If the
original container is not available, seal the unit in a plastic bag and then pack it
into a wooden or sturdy cardboard box large enough to allow 2 in. (5cm) of
cushioning material to surround the unit. For cushioning, use material such as
foam slabs that are capable of supporting the unit.
3. Label the box as shown below in Figure 2.1.
4. If shipping, mark the service center address and your return address on the
carton.
5. If storing, stack no more than 5 boxes high. Check the storage temperature range
specification in Appendix E.
Figure 2.1 Typical Box Label for Storage
POWER SUPPLY
Model Number:
Serial Number:
FRAGILE – ELECTRONIC EQUIPMENT
___________________________
___________________________