Multichannel broadcast commands, Specifications, Multichannel broadcast commands specifications – Xantrex Technology XDC User Manual
Page 119
Remote Operation
Multichannel Operation (6000 Watt only)
Release 3.0
117
Multichannel
Broadcast
Commands
Add a suffix of "0" to simultaneously broadcast the "command" to the master and all
other units on the CANbus. Only commands are allowed, queries are not allowed.
Note that there will be a lag in execution time between the local unit and all other
units of up to a maximum of 20 ms. For example:
SOURCE0:VOLT 10.0
will set all units in a multichannel string to 10.0 V
Specifications
Max connected units
50
Max cable length
40 m
Bus speed
700 kbits/sec
Termination
120 ohm 1/4 W
Connections
parallel male DB9 to female DB9 cable
Addresses
1 to 50