Xantrex Technology XDC - Manual (Page 211)

SCPI Com
m
an
d Refer
ence
SCPI Co
mmand Summary
Release 3.0
20
9
Table B.11Protection Commands
Table B.12User Lines
Table B.13Output State
Function SCPI Command Description Query
Set Over Temperature
Response [:]SENSe[]:TEMPerature:PROTection:LATCh
Select if output is latched off or auto
recovers in the case of an over temperature
condition Yes
Query Over Temperature
Protection Tripped [:]SENSe[]:TEMPerature:PROTection:TRIPped? Query temperature protection tripped N/A
Set AC Fail Response [:]SENSe[]:VOLTage:AC:PROTection:LATCh
Select if output is latched off or auto
recovers in the case of an AC Fail Yes
Query AC Fail Protection
Tripped [:]SENSe[]:VOLTage:AC:PROTection:TRIPped? Query AC protection circuit tripped N/A
Function SCPI Command Description Query
Select polarity of Auxiliary
Lines [:]OUTPut[]:AUXiliary:POLarity
{HIGH|LOW} Configure the polarity of the auxiliary line Yes
Select Source of Auxiliary
Line State [:]OUTPut[]:AUXiliary:SOURce
Configure the auxiliary line Yes
Query state of Auxiliary
Line [:]OUTPut[]:AUXiliary:STATe? Query the state of the auxiliary line N/A
Function SCPI Command Description Query
Set Output State [:]OUTPut[][:STATe] Enable/disable the power supply output. Yes
Set Output State at
Power-On [:]OUTPut[]:PON:STATe Selects the state of the output at power-on Yes
Power-On Configuration [:]OUTPut[]:PON:RECall
{LAST|PRESet|USER|SEQer>} Configure the supply to recall last setting,
one of the user settings, factory preset
values or to enable an auto sequence. Yes